Gtco Summagrid IV - Users Guide Part 2 Manual de usuario descargar pdf (Pagina 8)

Summagrid IV 8

1.6.3 Command Syntax

Prompt Mode

Prompt Character: Send New Report

Prompt Character: Resend Last Report

<ESC>M3

<ESC>G

<ESC>g

1.7 Report Modes: Point

1.7.1 Description

Point mode allows the tablet to send one coordinate pair each time a cursor or

stylus button is pressed.

1.7.2 When to Use

Point mode is best for mapping or other data collection applications; not

recommended for cursor steering applications.

1.7.3 Command Syntax

Point Mode

Send New Report

Resend Last Report

<ESC>M3

<ESC>G

<ESC>g

1.8 Report Modes: Point

1.8.1 Description

Stream mode allows the tablet to continually send reports to the host. Switch

Stream Mode grants the tablet to send reports to the host whenever a cursor or

stylus button is pressed. Both Stream and Switch Stream Mode send out reports at

a specified number per second. At 9600 baud, the maximum report rate is about 90

reports per second. If this default report rate is too fast for certain applications, you

may adjust the report rates using the Set Report Rate commands. The application

will recommend a required report rate.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sin comentarios

Gtco Summagrid IV - Users Guide Part 2 Manual de usuario Pagina 8