Gtco Surface-Lit AccuTab - Users Guide Manual de usuario descargar pdf (Pagina 8)

Surface-Lit AccuTab 8

2. Identify which upper corner blocks

you will need to remove:

 To replace bulb 1, remove A

and B.

 To replace bulb 2, remove B

and C.

 To replace bulb 3, remove C

and D.

3. Using a Phillips screwdriver, remove the

appropriate upper corner blocks by

discharging the two screws indicated. (To

prevent the upper corner block from falling

and possibly being damaged, keep one

hand on it while removing the two screws.)

4. Using a flat-blade screwdriver as shown, gently pry the bulb up at one end and then

remove it completely. Use of excessive force could shatter the bulb.

 If the heat sink stays attached to the bulb, remove any adhesive that it leaves

behind in the unpainted area on the lower extrusion (see figure in Step 5).

 If the heat sink remains attached to the lower extrusion, remove it using a

pair of pliers and then discharge any adhesive that it leaves behind in the

unpainted area on the lower extrusion (see figure in Step 5).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 69 70

Sin comentarios

Gtco Surface-Lit AccuTab - Users Guide Manual de usuario Pagina 8