Gtco MM II 1201 - Users Guide Manual de usuario descargar pdf (Pagina 34)

MM II 34

Transmission Control

The Stop Transmission and Resume Transmission commands act as software gates,

controlling data transmission from the MM II to the host. These commands control the

data flow, regardless of the report collection mode (Stream, Point, etc.). Stop Transmission

and Resume Transmission are equivalents of the protocols XOFF and XON.

Stop Transmission places the graphics tablet on standby. It is useful for systems that do

not constantly use the graphics tablet. End the standby state by sending the Resume

Transmission command.

While on standby, the tablet can buffer up to ten commands, which it executes after

receiving the Resume Transmission command.

If a Stop Transmission is issued while data is being transmitted, no data is lost. The MM II

severs the data transmission at the end of the byte. When a Resume Transmission

command is issued, the tablet resumes operation.

NOTE: The Reset command does not cancel the Stop Transmission command.

Z Commands

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 60 61

Sin comentarios

Gtco MM II 1201 - Users Guide Manual de usuario Pagina 34