Gtco AccuTab II - Users Guide Manual de usuario descargar pdf (Pagina 39)

AccuTab II 39

CalComp Emulation Commands

AccuTab II recognizes a subset of the CalComp 9500 command set. Space does not permit

a detailed description of CalComp commands. However, most of the commands in this

subset have equivalent AccuTab II commands. For further information about the operation

of those commands, please refer to the AccuTab II command or function description in the

GTCO CalComp by Turning Technologies AccuTab II Command Summary.

NOTE: CalComp commands must be terminated with a <CR>, which is not shown in the

codes listed here. Commands can be strung together by substituting an @ character for

the <ESC>% sequence after the first command and postponing the <CR> until the end of

the multiple command string.

Disable/Enable Echo

Code: ESC%En

Where n=0 to 3 (0 and 2 disable echo, 1 and 3 enable echo). If n is not included in the

command, echo is toggled on or off from its previous state.

(Equivalent to Enable Echo Mode, EM and Disable Echo Mode, hex 0F.)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 64 65

Sin comentarios

Gtco AccuTab II - Users Guide Manual de usuario Pagina 39