Gtco Roll-Up III - Quick Start Guide Manual de usuario descargar pdf

Contents

Verify that your Roll-Up III package includes the following:

 Roll-Up III digitizer and controller

 Transducer (stylus, 4-button or 16-

button cursor)

 USB cable

 CD with TabletWorks driver and

user’s manual

 Accessory pouch*

 Shipping/storage tube with insert*

*Do Not Discard

Optional Equipment

 Plan hold down clamps

 Deluxe travel case

 QuikRuler LCD module

 Serial interface cable and power

supply kit

Hardware Configuration

NOTE: Setup the hardware connections for USB or serial FIRST, following the instructions

below, then install the software.

Installing Roll-Up III

The following instructions describe how to assemble your Roll-Up III. Select a large, flat,

non-metal surface on which to place the digitizer. Clear all items from the surface.

NOTE: Conductive materials, inks, or

electronic devices on, under, or near the

Roll-Up III can cause improper operation.

1 2 3

Contents Verify that your Roll-Up III package includes the following:  Roll-Up III digitizer and controller  Transducer (stylus, 4-button or 16

NOTE: Connect ONLY USB or serial – not both. USB Connection – With TabletWorks CD Only – 1. Connect the transducer – cursor or stylus – to the app

Software Configuration NOTE: To configure Roll-Up III for use with a third-party application, please refer to the installation instructions in the

Sin comentarios

Gtco Roll-Up III - Quick Start Guide Manual de usuario